You can add a vanishing point to the ruler to match the shape of the fisheye.ġ. You can also enable snapping to the ruler or grid to help in your drawing. You can adjust the guide lines and vanishing point according to what you want to draw. The lower right controller lets you turn the snap function on and off. The upper left controller changes the position of the controller to move the entire ruler. Many waxes and polishes contain silicone, the most common cause of. You can change the position and angel of the eye level (blue).Ĭhange the position of the eye level with the central controller and change the angle by moving the small controllers on the sides.Ī vanishing point snapped to above the eye level will also be moved if you move the eye level.Īs outlined in “Adjusting the fisheye distortion,” you can move the entire fisheye perspective ruler position. Fish eyes are most often caused by improper or insufficient surface cleaning or preparation. However, you must be careful not to damage the surface. This phenomenon you are noticing is referred to in the industry as fish eye. The defects you are experiencing can be introduced into your coating from your compressed air supply, cleaning solutions, silicones, greases, waxes, and even the oil in your hands. If you have coarse grit sandpaper, this will work quite well. Contaminants are a reality with coatings. In this case, you already have fish eyes in the surface of the finish.
You cannot move the controller outside the lens circle.ĭrag the controller to change the center of the fisheye lens. The best way to remove paint and lacquer fisheye is to sand the area to remove the contaminant and then use a stripper or thinner to get rid of the finish. It usually takes 1-3 squirts from the bottle to get the finish to flow out without the fish eyes. The snap function can be switched on and off with the square controller on the lower right of the white circle. You can change the slope of the angle of the guide line by dragging the blue circles at both ends. It reduces surface tension of the wet paint film improves flow-out. Drag and move the middle white circle to move the guide lines. Our Custom Shop KE215-HP Fisheye Eliminator Additive prevents fisheyes and increases gloss.
0 kommentar(er)
